Geissele SAG 6mm Suppressor Alignment Gage 10-1642-F

Geissele SAG 6mm Suppressor Alignment Gage 10-1642-F verifies the alignment of a suppressor to the bore of a firearm barrel, catching a misalignment problem most shooters never think to check for.

This Suppressor Alignment Gage works because a suppressor is usually much longer than the barrel-to-muzzle-device interface, so a small deviation at the mounting point translates into a much larger deviation at the suppressor's exit hole. Those small deviations can also compound rather than cancel out, making misalignment worse the farther down the suppressor's length it travels — worth checking on any 6mm precision build where accuracy is already the whole point.

Manufactured from hardened steel and ground 0.002" under nominal bore diameter, this Geissele SAG 6mm Alignment Gage is finished straight to 0.001" over its full length. That length is what does the actual aligning work — the gage's own straightness carries the alignment check down the suppressor's full length rather than relying on an overly tight bore fit. Geissele hardens the SAG specifically so it resists wear from abrasive powder residue and won't pull burrs if it contacts misaligned baffles inside the suppressor.

Key Features:

• 6mm caliber
• Hardened steel construction
• Ground 0.002" under nominal bore diameter
• Straight to 0.001" over its entire length
• Resists wear from powder residue and baffle contact
• Identifies complete pass, partial failure, and complete failure conditions
• Black finish
• Made in the USA

This suppressor alignment gage turns a guessing game into a verifiable check, catching misalignment on a 6mm platform before it becomes a baffle strike.